3) Charging the battery and battery life
Charging your instrument
To charge your instrument, simply connect the instrument’s USB-C port to a USB power source (computer, wall charger, power bank, etc.).
You can check the charge status directly on the instrument’s screen. The charge LEDs also indicate the status:
Red LED: instrument charging
Blue LED: battery fully charged
A full charge takes approximately 3 hours.
The instrument can be used normally while charging, including during flight.
To stop charging, simply disconnect the USB-C cable. The Li-ion battery has no memory effect.
⚠️ Important note: To preserve battery lifespan, in case of long-term storage (several months), it is recommended to keep the instrument at around 60% charge. Avoid storing the instrument with a fully discharged or fully charged battery for extended periods.
⚠️ Important note: Avoid exposing the instrument to high temperatures (for example behind a windshield in direct sunlight or near a heat source), especially while charging. High temperatures accelerate battery aging.
⚠️ Important note: To ensure optimal charging and instrument safety, use a compliant USB charger. Charging via a computer USB port, power bank, or standard wall charger is perfectly suitable.
Estimated battery life
Battery life depends on several usage parameters. Depending on the selected settings, it can vary significantly.
Below is a table providing an estimated battery life depending on your usage:
Power saving mode
OFF
Disabled
≈ 60 h
≈ 30–35 h
Leisure flight
AUTO
Disabled or occasional
≈ 50 h
≈ 25–30 h
Cross-country / competition
AUTO
Continuously enabled
≈ 40 h
≈ 20–25 h
Permanent high brightness
Maximum
Continuously enabled
≈ 25 h
≈ 15 h
The Alti V4 offers approximately twice the battery life of the GPS V4 under typical usage.
Last updated