Syride Manuals
Evo V1 English manual
Evo V1 English manual
  • Foreword
  • I. Setup Syride communication software
  • II. Turn ON and OFF the flight computer
  • III. Charge the battery
  • IV. Place the instrument in flight
  • V. General ergonomics
  • VI. The 3 main menus
  • VII. Parameters : system information
  • VIII. Parameters : Wi-Fi and Bluetooth setup
  • IX. Parameters : online functions
  • X. Parameters : GNSS setup
  • XI. Parameters : flightbook
  • XII. Parameters : advanced parameters (instrument)
  • XIII. Navigation : GOTO menu
  • Navigation : add/edit/delete waypoints menu
  • XV. Navigation : load a route menu
  • XVI. Navigation : add/edit/delete a route menu
  • XVII. Navigation : airspaces menu
  • XVIII. Advanced setup (software)
  • XIX. Customize the flight screen and the vario
  • XX. Transfer your flights
  • XXI. Suggestion of use
  • Important Warnings and Safety Instructions
Powered by GitBook
On this page

III. Charge the battery

PreviousII. Turn ON and OFF the flight computerNextIV. Place the instrument in flight

Last updated 3 months ago

  1. In order to charge the instrument, just use any mini-USB cable that you could connect to any power supply (computer, phone charger, cigarette lighter..). A red light on the battery icon indicates the flight computer is charging. A full charge from an empty battery takes up to 8 hours. It is NOT recommended to charge through a USB hub device.

  1. If the instrument is connected to a computer a screen symbolizes it. You can disconnect it at any time.

  2. In running mod, draw a “slide-down” movement on the screen with your finger in order to display the top banner during a few seconds.

  1. Disconnect the instrument to stop charging it. The Li-ion battery isn’t affected by a memory effect.