Syride Manuals
Nav V3 English manual
Nav V3 English manual
  • Foreword
  • I. Setup the SYS PC Tool
  • II. Place the instrument
  • III. Recharging the battery
  • IV. Information about GPS state
  • V. Menu synoptic
  • VI. Flight screens
  • VII. Configure your device
  • VIII. Advanced configuration
  • IX. Customize your screens and vario sound
  • X. Height above ground
  • XI. Locate airspaces
  • XII. Navigation
  • XIII. Display and delete a flight
  • XIV. Warnings and reset
  • XV. Transfer your flights
  • XVI. Parameters
  • XVII. Suggestion of use
  • Important Warnings and Safety Instructions
Powered by GitBook
On this page

VI. Flight screens

PreviousV. Menu synopticNextVII. Configure your device

Last updated 5 months ago

1. Screens #1 to #4 shows the informations you previously choosed. If your device do not receive a GPS signal strong enough, NO GPS will appear.

  1. Pressing the central button will turn OFF and ON the sound of the vario. This is usefull when you need to concentrate on a transition or when landing.

  1. Press the central button on the screen #6 in order to save your current GPS position. The result will show you the distance, the vertical gain from that point and a route indication to return to this saved position.

  1. Screen #5 (MAP screen) displays on the whole LCD area. You can see:

  • Your current position and heading on the middle of the screen.

  • The topography grayscaled (if previously uploaded to the instrument).

  • Airspaces (if previously uploaded to the instrument).

  • Your GPS trace for the last 10 minutes.

  • Waypoints and optimized navigation route (if a route is loaded).

Pressing the middle button changes the zoom level.