Syride Manuals
Nav V3 English manual
Nav V3 English manual
  • Foreword
  • I. Setup the SYS PC Tool
  • II. Place the instrument
  • III. Recharging the battery
  • IV. Information about GPS state
  • V. Menu synoptic
  • VI. Flight screens
  • VII. Configure your device
  • VIII. Advanced configuration
  • IX. Customize your screens and vario sound
  • X. Height above ground
  • XI. Locate airspaces
  • XII. Navigation
  • XIII. Display and delete a flight
  • XIV. Warnings and reset
  • XV. Transfer your flights
  • XVI. Parameters
  • XVII. Suggestion of use
  • Important Warnings and Safety Instructions
Powered by GitBook
On this page

XIV. Warnings and reset

PreviousXIII. Display and delete a flightNextXV. Transfer your flights

Last updated 5 months ago

If this happens, be sure the instrument’s memory is not full and check the battery is charged enough.

To protect from flights corruption, your instrument will automatically stop recording the flight if the battery is too low, or if memory is almost full. This is indicated when the plane icon on the top left of the screen is blinking with a cross over it.

If the G-Meter exceeds the value selected in “Configure my instrument” menu of SYS PC TOOL (2,5 g is the default value), a highly noisy sound will activate (even if the sound is turned-off).

If ever your instrument would stuck (unresponsive to buttons), plug the device to your computer with the USB cable and press the reset button with a needle in the hole on the back of the instrument (keeping the USB plugged).